The data that you must enter in the software CRANKSHAFT BALANCE DESIGN are divided in four areas. For first you must enter the geometry of the crankshaft, and the masses of the moving parts. |
 |
Regarding the geometry of the crankshaft you must enter the dimensions that you see in the figure, or doing simple
geometric reliefs if the crankshaft is already existing, or
fixing the dimensions of the crankshaft that you want to study
preventively.
For the masses of the moving parts you must simply weigh the elements of slider crank (piston pin and snap rings, piston and rings, small-end and
big-end of the connecting rod) |
 |
|
|
|