In addition to the charts with the carburetion and the advice to change jetting both at partial loads, both at full load, the software the software
SET-UP Carburetor Professional performs an automatic calculation of
the changes to make at the initial jetting to optimize
the carburetion.
For first calculates how should be modified idle
jet (or the idle atomizer if present) and the main jet,
keeping fixed all the other calibration elements that have been
inserted (red rectangle in the image).
After that change the other calibration elements in the right direction
and calculates again the optimal idle jet and the optimal main jet for each of these new calibrations.
These other calibrations calculated by the software are very important
as if the initial jetting is very wrong to act only
idle jet and main jet may not be sufficient, therefore,
software change one by one the other initial elements of calibration
(red circles in the figure) in order to find solutions
which may be significantly better than the jetting
initial.
This great feature of the software SET-UP Carburetor
Professional not only allows you to optimize your jetting
very quickly, but you can find solutions that
can further refine it allowing you to maximize
engine performance in all operating conditions.