The software SET-UP Carburetor Power shows you in a few seconds the
carburation that you get with the setting that you have on the
carburetor, or that you want to test, and how this is compared to
the optimal one for your engine in the different driving conditions.
For fiirst, it shows you how is the carburetion accelerating
from slow corners. The reference is the value 1 so you can
easily see at the different throttle openings where the
carburation is optimal, where it is lean, and where it is
rich, thus being able to act in the correct direction to
optimize it.
The software then shows you what happens at full load to
vary the engine speed, to maintain the optimal carburetion
throughout all the engine operating range.
Finally the software shows you is the carburetion
accelerating from fast corners, or in the case of the KZ,
accelerating after the gear shift, in this way you can
easily see how the carburetor setting that you use is
adapted to the different characteristics of the track
finding the best compromise to get the best performance on
the lap for each track.
In addition to the graphs, the software summarizes the
situation in the different phases of opening or operating
engine speed (0-25% 25-50% 50-75% 75-100%) in this way, as
we shall see following, it will be easy to understand on
which calibration elements will be necessary to intervene to
optimize the carburetion. The software in fact shows you how
much you deviate percentage from the optimal in every
condition, helping you also with colors to understand where
the carburetion tends to lean (colors towards blue), where
it tends to rich (colors towards red), and where instead it
is optimal (green).
Finally the software shows you two indexes to make you
easily understand how globally your carburetor setting
approaches the optimal 100% as regards combustion efficiency
and the level of mixture atomization that can be obtained in
the various driving phases.